Knowledge

Inner box made from stainless steel grade 304a No.1 widely used in the industries, which is goods for hygienic products, as it perfectly works in extremely low temperature.

Outer box made from aluminum trims. Aluminum features are light, heat reflective, high endurance for rust and corrosion.

Exterior
Surface - Iron coated by Zinc with anti-corrosion sprayed
Left-Right wall – Flat aluminum trims
Front wall, door – Flat stainless steel
Roof- Flat aluminum

Signal light, lighting indicates the height according to department of transport Act.

Side box made from stainless steel.

2 stainless steel back doors installed with the completed implement set.

Back ladder, stainless steel folding ladder covered by checkered plate.

-Completed air conditioning system.
-100% Genuine Sanden (Singapore) compressor.
-100% Genuine Refrigerant R404a.

Length of the box and expansions maximum 2.55 m. (excluded the side mirrors). Gap between the box with expansion and the outer wheel, must not over 15 cm.

Height followed the department of transport Act.
From bottom to top, must not over 4.00 m (excluded the mirrors).

Extension followed the department of transport Act. From the tip of the box (excluded bumper) to the axle rear center or group of the axle center (if more than one), must not over 2/3 of the wheelbase.

Mudguard followed the department of transport Act.
The size matched the wheel made from metal, rubber or others. At the back wheel, tip of the mudguard must not higher than 25 cm. from the ground.

Lamp followed the department of transport Act.
Lamp to indicate the height and type of vehicle, 4 green lights placed at top-front of the vehicle

-Lamp (red light), indicate height placed on top-back 2 spots, edge of the box 1 of each side.
- yellow flashing light placed at the back 2 spots.
-Back lamp (red light), placed at the back 2 spots left and right.
-Stop lamp (red light), placed at the back 2 spots left and right.
-Reversing lamp (white light), maximum 2 spots at the back.
-License plate lamp (white light), clearly illuminated the plate 1 spot.

Refrigerator systems
1. Direct Drive DIRECT
2. Stand-by
3. SUB ENGINE

COMPRESSOR DENSO 10PA20C (By Japan)
for Direct Drive DIRECT and Stand-by systems want to Refrigerate 0 ° Celsius – 20 ° Celsius

COMPRESSOR COMBOCK FKX30/325 (By Germany)
for SUB ENGINE systems want to Refrigerate 0 ° Celsius – 20 ° Celsius

COMPRESSOR COMBOCK FKX40/560 N (By Germany)
for SUB ENGINE systems want to Refrigerate 0 ° Celsius – 25 ° Celsius

High purity gas
High purity gas R 134a for +35 ° Celsius – 0 ° Celsius
High purity gas R404a for -0 ° Celsius – 30 ° Celsius